D. Installation of Telephone Voice Activation Module

1. Mount the voice activation control module (A35/11) to the bracket with M4 self-tapping TORX screws (Figure 14).

2. Lower the assembly into the rear of the wheel well.

3. Connect the 15-pole D-sub- and optical connectors to the voice activation module.

Note:
Be sure all fibers are free (not tied) and maintain a bend radius no smaller than 25 mm.

4. Place the back leg of the voice activation module bracket over the stud on the quarter panel and the front leg over the pre-punched hole in the trunk rail.

5. Secure the front leg of the bracket to the trunk rail with an M5x10 self-tapping screw, but do not tighten completely.