Preparation For Test

WARNING: DANGER. Disconnecting the connector or tilting of the power soft top control module (N52) upon removal, will cause the roll bar to deploy Be certain to keep persons away from deployment radius of the roll bar. Risk of injury.

Preparation for Test:
1. Check fuses F1-19, F1-20, F20-1, F20-2, F20-3, F20-4, F20-7, F20-8, F20-9, Ok,
2. Battery voltage > 11 V,
3. RB MIL (A1e29) is illuminated in instrument cluster.

Special Tools:

Electrical wiring Diagrams
Refer to the applicable Wiring Diagram.

Connection Diagram - Socket Box With Connector X1

WARNING: DANGER. Disconnecting the connector or tilting of the power soft top control module (N52) upon removal, will cause the roil bar to deploy. Be certain to keep persons away from deployment radius of the roll bar. Risk of injury.

- Ignition: OFF
- Disconnect connector X2 from control module
- Connect socket box

Figure 1:

01 Vehicle harness set connector (12-pole)
002 Test cable (12-pole) pan no. 120 t89 01 63 00
003 Multimeter
004 Socket box
N52 Power soft top control module

Connection Diagram - Socket Box With Connector X2

WARNING: DANGER. Disconnecting the connector or tilting of the power soft top control module (N52) upon removal, will cause the roil bar to deploy. Be certain to keep persons away from deployment radius of the roll bar. Risk of injury.

- Ignition: OFF
- Disconnect connector X2 from control module
- Connect socket box

Figure 2:

01 Vehicle harness set connector (35-pole)
002 Test cable (35-pole), part no. 104 589 00 83 80
003 Multimeter
004 Socket box
N52 Power soft top control module