Operation CHARM: Car repair manuals for everyone.

AN80.50-P-0001-01P Retrofit Wiring Harness



AN80.50-P-0001-01P Retrofit Wiring Harness






220 589 01 99 00, Wiring harness repair kit






1 3-pin coupling for alarm signal siren with auxiliary battery (H3/1)
2 5-pin coupling for rear SAM control module with fuse and relay module (N10/2)
3 3-pin coupling for ATA tilt sensor (B33)
4 Wire br for right major assemblies compartment ground, wire ground (W16/4)






1 Contact 3-pin coupling for ATA tilt sensor (B33).
2 Contact 5-pin coupling for rear SAM control module with fuse and relay module (N10/2).
3 Remove plug (7) via left rear wheel well.
4 Attach wiring harness with tie straps to existing wiring harness (arrow) and guide via left rear wheel well to the vehicle passenger compartment.
5 Route wiring harness in left sill cable duct as far as the driver's seat.






6 Route wiring harness in cable duct via tunnel to the right sill.
7 Route wiring harness in right sill cable duct.
8 Route wiring harness in passenger side footwell to cable duct (12) in engine compartment (arrows).
Secure to existing wiring harness with tie straps.






9 Press out locking pin (arrow) from cable duct (12) with screwdriver.
10 Unplug wires from 3-pin coupling (1) for alarm signal siren with auxiliary battery (H3/1).
Observe installation position of wires.

11 Detach grommet carefully from wiring harness.
Observe installation position.






12 Route wiring harness through exposed duct (arrow) of cable duct (12) to the engine compartment.
Secure to existing wiring harness with tie straps.






13 Slide grommet onto wiring harness and position.
14 Guide wiring harness through bore (arrow) in upper right inner longitudinal member (13).
15 Position grommet in the bore (arrow).
Ensure correct seating of grommet.






16 Assemble 3-pin coupling (1) for alarm signal siren with auxiliary battery (H3/1).
Check correct latching of the female contacts in the connector housing by carefully pulling on the appropriate wire.
Ensure correct seating of rubber gasket.

17 Route wiring harness to the alarm signal siren with auxiliary battery (H3/1) and secure with adhesive felt (arrows) to lower right firewall (14).
18 Contact 3-pin coupling (1) for alarm signal siren with auxiliary battery (H3/1).
19 Connect wire br (4) for right major assemblies compartment ground,wire ground (W16/4).