GF80.45-P-2003PP Convenience Closing/Opening With Transmitter Key Function

GF80.45-P-2003PP Convenience Closing/Opening With Transmitter Key Function

MODEL 203 up to Model Year 8







Convenience opening/closing via infrared signal
Networking of components shown on model 203.0

A8/1 Transmitter key
A26/1 Left front IR receiver unit
A26/2 Right front IR receiver unit
M10/3 Left front power window motor
M10/4 Right front power window motor
M10/5 Left rear power window motor
M10/6 Right rear power window motor
M12m1 Roof system motor
N69/1 Left front door control module
N69/2 Right front door control module
N69/3 Left rear door control module
N69/4 Right rear door control module
N70 Overhead control panel control module
N73 EIS [EZS] control module

Function requirements
- Circuits 15C, 15R and 15 off
- No overvoltage or undervoltage
- All doors closed and
- No other control module sending central opening/closing signals
- Unlock/Lock button on transmitter key (A8/1) pressed for longer than 1 s.

Function

The corresponding control modules receive the CAN messages for convenience opening/closing and actuate the required motors. The motors remain actuated for as long as the button on the transmitter key is pressed, though for no longer than 25 s.

The convenience opening/closing function for the power windows operates even if windows are not normalized.

The convenience opening/closing function is aborted if
- An obstruction is detected, or
- The request is no longer received via the CAN, or
- The function requirements listed above are no longer satisfied.