Operation CHARM: Car repair manuals for everyone.

Electronic Selector Lever Codes

Version 210 Electronic Selector Lever Codes

DTC Test scope

P1000 Control unit N15/5 (Electronic selector lever module control unit) is defective.�

P1750 The supply voltage of the control unit is too low (undervoltage).�

P1817 [1] : Component Reversing lamp has a short circuit to ground.�

P1817 [2] : Component Reversing lamp has a short circuit to positive.�

P1817 [3] : No supply voltage at terminal 15 for reversing light.�

P1832 The output stage in control module N15/5 (Electronic selector lever module control unit) has Short circuit.�

P1833 The output stage in control module N15/5 (Electronic selector lever module control unit) has Open circuit.�

P1856 Selector lever position detection has failed.�

P1860 The right rear wheel rpm signal sent from the traction system via the CAN bus is implausible.�

P1861 The left rear wheel rpm signal sent from the traction system via the CAN bus is implausible.�

P1875 CAN communication with other control units installed in this vehicle is not possible.�

P1876 The signals sent by control unit N47 (Traction systems control module) for the wheel speeds and the braking torque are not available on the CAN bus.�

P1910 The supply voltage of the control unit is too high (overvoltage).�

P1912 The pushbutton signals are implausible.�

P1925 The braking torque value sent from the traction system via the CAN bus is implausible.�

P1926 The stop lamp feedback transmitted by control unit N73 (EIS [EZS] control unit) over the CAN bus is not available.�

P1927 The braking signal sent from the traction system via the CAN bus is implausible.�

P1928 The brake signal from control unit N47 (Traction systems control module) is not available on the CAN bus.