Headlamp Switch: Service and Repair

Removing And Installing Light Module

Illustrated On Model 210:

1 Disconnect ground cable from battery

CAUTION: Insulate terminal on ground cable to prevent unintentional contact between disconnected ground cable and ground W10.

2 Unhook control cable on release lever for parking brake and remove release lever guide

NOTE: Installation: Clip release lever guide into mount on light module housing opposite direction of forward motion

3.1 Remove bottom section of instrument panel (driver's side)
3.2 Remove cover below instrument panel (driver's side)
4 Unhook and disconnect electrical connections (4) on rear of light module (N7-1)

NOTE: Installation: Complete electrical connections only after installing light module

5 Unscrew screws (3, 5)

NOTE: Installation: First screw in screw (3) in area of parking brake release lever While screwing in support light module from below with hand and align on hole for second screw

6 Remove light module (N7/1) from instrument panel

7 Reinstall in opposite order