Limit Switch, Cloth Holding Brace Up

Preliminary jobs:
Remove occasional (rear) seats or baggage shelf.
[1][2]Procedures or
Service and Repair
Remove side panelling at rear.








Removal
Top
move to position A with top switch or manual actuation.
Screw (1)
screw out of cable guide
Plug connector (S84/6x)
disconnect
Top
move to position B
Ignition
switch off
Cloth holding brace
press in direction "closed" until screws (2) can be reached with screwdriver
Screws (2)
screw out
Limit switch (S84/6)
remove together with cable

Installation
Install in opposite order


NOTE: Lay limit switch cable along flexible hydraulic lines


Adjustment
Connect multimeter to plug connector (S84/6x). Set multimeter to continuity test (acoustic signal).
Adjust limit switch (S84/6) by moving in oblong holes.
Limit switch (S84/6) should switch approx. 100 mm before reaching the uppermost position of the cloth holding brace.