(Figure 1).

(Figure 2).

^ (Figure 3).

^ < ME2-SFI - Motor electronics/Control unit adaptations> (Figure 4).

^ (Figure 5).

^
(Figure 6)

Note:

Disregard on-screen instructions to insert
SDflash CD (this was done in step 1) select
F2 to continue.

^ (Figure 7).

Note:
The numbers displayed on the screen (Figure 7) under Engine control module" (OLD/NEW) are not actual engine control module part numbers (these numbers are for internal use).

^ . (Figure 8).

WARNING!
Engine cooling fan will run during programming.

^ After programming has been completed switch ignition: OFF

Wait 10 secs. (Figure 9), switch ignition ON
(when instructed by on-screen message).

Note:
After flashing, control module version will have been changed.

^ Process has been completed>: Follow on-screen instructions to erase fault memory.

^
6. Perform version coding:

^ For models as of MY 2003 perform SCN coding procedure (refer to S-SI-07.081001)

^ For all other models version coding is performed using Star Diagnosis.

7. Start engine.

8. Disconnect battery charger.

In Case of Warranty