GF82.30-P-3004PQ Windshield Wiper, Function

GF82.30-P-3004PQ Windshield Wiper, Function

MODELS 203.0 /2 /7 as of 24.4.04







1 Circuit status
2 Request signal
3 Actuation and position feedback
M6/1 Wiper motor
N10/1 Front SAM control unit with fuse and relay module
N73 DI control unit N80 Steering column module
S4 Combination switch
CAN-B Controller area network bus class B (interior compartment) (CAN B)

Function prerequisites:
- Circuit 15R ON

Function
The function requests from the combination switch (S4) are relayed over the steering column module (N80) to the front SAM control unit with fuse and relay module (N10/1). The front SAM control unit with fuse and relay module (N10/1) actuates the wiper motor (M6/1) in accordance with the requests.

- For continuous wiping at slow speed (stage 1, approx. 40 cycles per min.), turn combination switch (S4) to position "II".
- For continuous wiping at fast speed (stage 2, approx. 60 cycles per min.), turn combination switch (S4) to position "III".
- For touch wiping, briefly push combination switch (S4) to detent point.

By briefly pressing the combination switch (S4), a single wipe is performed, when pressing for longer the wiping continues in accordance with the duration that the switch is actuated. Touch wiping takes place independently of the wiper level that has been selected.