Starting System - Engine Will Not Start
Date: December 22, 2005Order No.: P-B-15.30/55a
Supersedes: P-B-15.30/55 dated August 24, 2005
Group: 15
Revision: Addition of Model 211 and Applicable Procedure
SUBJECT:
Model 203.040/052/054/056/061/064/065/076/081/084/087/092/261/264/281/284/740/
747/764
Model 209.356/365/375/376/456/465/475/476
Model 211.026/056/065/070/076/082/083/087/256/265/276/282/283/287
All Model Years
Engine Not Starting / Starter Fuse Malfunctioning
If you receive customer reports in the above model vehicles of the engine not starting, the Starter Fuse in the Driver Signal Acquisition and Actuation Module (SAM) may be malfunctioning. The Driver SAM should be fitted with a larger 20 Amp fuse.
Procedure for Model 203 / 209
1. Perform a visual inspection of the Driver SAM (N10/1) and determine which fuse is installed in socket 52 (Figure 1, arrow). Consult STAR Finder for more information on the location of this fuse (10/1f52).
2. Replace the currently installed 15 Amp fuse with the 20 Amp fuse specified in this DTB.
3. Record the fuse rating change on the vehicle's Fuse Chart.
Procedure for Model 211
1. Perform a visual inspection of the Driver SAM (N10/1) and determine which fuse is installed in socket 59 (Figure 2, arrow). Consult STAR Finder for more information on the location of this fuse (10/1f59).
2. Replace the currently installed 15 Amp fuse with the 20 Amp fuse specified in this DTB.
3. Record the fuse rating change on the vehicle's Fuse Chart.
Parts Information
Note:
The following allowable labor operations should be used when submitting a warranty claim for this repair.
In Case of Warranty, use the table.