AR54.21-P-1261I Remove/Install SAM Control Module With Fuse and Relay Box, Front Right

AR54.21-P-1261I Remove/Install SAM Control Module With Fuse and Relay Box, Front Right

Shown On Model 220:

Removing, installing
1 Connect quiescent retention device
2 Disconnect ground cable from battery
3 Open engine hood and position upright
4 Unlock and remove cover on right fuse box (F1.1)
5 Fold up clamping lever (1) of supply (terminal 30) and remove cable
6 Unclip fuse carrier (4) on control module unit (passenger-side SAM control module (N10/7) with right front fuse and relay module (K40/7)).

NOTE:
- Once the retaining lugs (arrow) have been pressed in the direction of the arrow, the fuse carrier can be taken out from the top
- The components fitted to the right front fuse and relay module may vary depending on the equipment.

7 Remove the remaining couplings on the front right fuse and relay module
8 Pull out control module unit from above

CAUTION: Only pull out until the couplings (3) on control module unit (right front fuse and relay module (K40/7) and passenger-side SAM control module (N10/6)) are accessible

9 Unlock and remove couplings (3)
- If passenger-side SAM control module or right front fuse and relay module are defective: Disconnect SAM control module from fuse and relay module

10 Install in reverse order.