G. Final Assembly and Function Testing

1. Program the telephone per S-B-82.70/179A, "V60 Portable Telephone Programming."

2. Verify proper telephone, and voice control operation per the following checklist:

Telephone
^ Handset dialing is functioning
^ Head unit dialing is functioning
^ Handset incoming/outgoing call audio is clear
^ Hands-free incoming/outgoing audio is clear
^ Automatic memory download is functioning (It may be necessary to store a test number in the telephone handset for this feature to operate.). After automatic download, stored numbers should be available for dialing from the head unit.
^ Verify the telephone mode is available in the 1CM
^ Verify operation of the steering wheel controls

Voice Control
^ Verify the VCM can be controlled by the PTT lever on the column
^ Verify spoken instructions are functioning with a high recognition rate
^ Verify the VCM can control the telephone

3. Install the left trunk liner panel:

a. Work the back edge of the left trunk liner into the rear trim-panel groove.

b. Work the left side of the liner into place, making sure the bottom edge locks into the top edge of the amplifier bracket.

c. Work the bottom of the liner back into the plastic trim in the rear.

d. Work the top of the liner back into the plastic trim in the rear.

e. Close the access panel to the tail lamp.

f. Replace the screw and cargo net clip at the front bottom edge of the liner.

g. Replace the plastic retaining clip at the top of the liner.

4. Reinstall the trunk mat.