GF40.15-P-0001-02TA The Pressure Monitor (TPM), Activation

GF40.15-P-0001-02TA The pressure monitor (TPM), activation
- 211 up to 31.5.04
- with CODE (475) Tire pressure indicator

Component Identification:

In the event of the driver changing the air pressure, in the event of exchanging a wheel or changing a tire, the adjusted air pressure values must be stored in the TPM [RDK] control unit (N88) as specified monitoring values.

Proceed as follows:
^ Correct the air pressure at each wheel.
^ Switch on ignition (circuit 15).

Engine ON or OFF.





^ Using the scroll forward/back button (S110s1), select the tire pressure monitor system.

Component Identification:

^ Press the instrument illumination dimmer and reset button (A1r1). The previous display changes to the selection screen with preselection "No".





^ Press the "+" button on the + and - push-button (setting specific functions and volume control) (S111s1) on the multifunction steering wheel. The selection screen with selection "Yes" appears for approx. 2 seconds and then changes immediately to the confirmation screen.

All other buttons cause the activation sequence to be aborted.





^ The adjacent system message ensues immediately after the engine starts.

If activation is carried out when the engine is running, this message appears with a time delay of approx. 30 seconds.





^ The current tire pressures are displayed after driving for approx. 10 minutes. The activation process is complete.