GF40.15-P-0001-02TB Tire Pressure Monitor (TPM), Activation

GF40.15-P-0001-02TB Tire pressure monitor (TPM), activation
- 211 as of 1.6.04 up to 31.5.05
- with CODE (475) Tire pressure monitor
- except CODE (494) USA version
- except CODE (498) Japan version
- 211 as of 1.6.04 up to 30.6.05
- with CODE (475) Tire pressure monitor
- with CODE (494) USA version

Component Identification:

In the event of the driver changing the air pressure, in the event of exchanging a wheel or changing a tire, the adjusted air pressure values must be stored in the TPM [RDK] control unit (N88) as specified monitoring values.

Proceed as follows:
^ Correct the air pressure at each wheel.
^ Switch on ignition (circuit 15).

Engine ON or OFF.





^ Use the scroll forward/back push-button (S110s1) to select the tire pressure monitoring system.

Component Identification:

^ Press instrument illumination rheostat and reset button (A1r1). The previous display changes to the selection screen with preselection "No".





^ Press the "+" button on the + and - push-button (setting specific functions and volume control) (S111s1) on the multifunction steering wheel. The selection screen with selection "Yes" appears for approx. 2 seconds and then changes immediately to the confirmation screen.

All other buttons cause the activation sequence to be aborted.





^ Once the engine has been started the system message shown opposite appears immediately.

If activation is carried out when the engine is running, this message appears with a time delay of approx. 30 seconds.





^ After approx. 10 min journey time the current tire pressures are displayed. The activation process is complete.