AR54.21-P-1259I Remove/Install Sam Control Module With Fuse and Relay Box In Rear

AR54.21-P-1259I Remove/Install Sam Control Module With Fuse and Relay Box In Rear

Shown On Model 220:

Removal, installation
1 Connect quiescent current retention unit
2 Disconnect ground lead from battery
3.1 Remove rear seat cushion
3.2 Remove bucket seats
4 Remove seat adjustment device on rear seat
5 Unscrew screws (2) and nuts (1), remove mounting plate (3) from vehicle floor and pivot toward rear
6 Pivot arresting lever (5) for power supply (c, 30) up and pull out wire
7 Unscrew nuts (4) and remove control module unit (rear fuse and relay module (K40/5) and SAM control module in rear (N10/8) from floor
8 Disconnect connectors from control module unit (rear fuse and relay module (K40/4) and SAM control module in rear (N10/8))
9 Unclip fuse carrier (6) from fuse and relay module in rear

NOTE:
- After pressing the retaining lugs (arrow) in the direction of the arrow the fuse carriers can be removed upward.
- The number of fuse carriers from the fuse and relay module in the rear can vary depending on the equipment and vehicle. If SAM control module in rear or fuse and relay module in rear are defective: Disconnect SAM control module from fuse and relay module

10 Install in opposite order.