AR80.35-P-0001QA Remove/Install Keyless Go Control Module in Door

AR80.35-P-0001QA Remove/Install Keyless Go Control Module in Door
- with CODE (889) Keyless Go
- control unit in door






1 Remove door liner

DANGER!
Risk of explosion from explosive gas. Risk of poisoning and caustic burns from swallowing battery electrolyte. Risk of injury through burns to skin and eyes from battery acid or when handling damaged lead-acid batteries
- No fire, sparks, naked flames or smoking.
- Wear protective gloves, acid-resistant clothing and safety glasses. Pour battery electrolyte only into suitable and appropriately marked containers.

2 Disconnect ground cable of battery
3 Pull off door foil (1) at top right and attach using adhesive tape

NOTE:
- Carefully remove door foil (1) and check thoroughly for damage, replace if necessary
- Installation: Press on door foil (1) using roller.

4 Unclip left door keyless go control module (N69/8), right door keyless go control module (N69/9)
5 Disconnect connectors (2)
6 Install in the reverse order
7 Perform basic programming
8 Read diagnostic trouble code memory and erase
9 Perform function check