B. Mounting the MHI Control Module, Linear Compensator, and Antenna Switch to the Bracket

1. Mount the MHI control module to the bracket front with four 8 mm self-tapping screws (Figure 2).

Note:
The mounting holes for the MHI control module line up with the bracket holes only one way (i.e. it is not possible to mount the MHI control module to the bracket incorrectly).





2. Mount the linear compensator to the bracket backside with three Ti 5 Torx self-tapping screws (Figure 3).

Note:
Position the linear compensator with the connector receptacles facing the bracket bottom (i.e. the end facing the bottom of the vehicle when the bracket is installed) (Figure 3).





3. Mount the antenna switch to the bracket top with two T15 Torx self-tapping screws (Figure 4).

Note:
The antenna switch must face the bracket side with the linear compensator