AR05.10-P-7601-02AV Rivet Timing Chain

AR05.10-P-7601-02AV Rivet timing chain

Camshaft:

Special Tools:

1 Place assembly insert (1) with the digit F1 into the riveting tool (2) and secure with bolt (3).

Component Identification:

2 Place movable assembly insert (4) with the digit D5 into the riveting tool (2).

Component Identification:

3 Insert new outer plate (5) into the movable assembly insert (4).
The outer plate (5) is held by a magnet.

Component Identification:

4 Mark camshaft sprocket relative to timing chain by a colored dot (arrow).
5 Remove camshaft sprocket (6).

Component Identification:

6 Place a cloth below timing chain.
7 Position riveting tool (2) so that timing chain is resting on the spacer bars (arrow).

Component Identification:

8 Tighten spindle (7) until a firm resistance is felt.
While turning the spindle (7) ensure that the pins of the riveted link are inserted into the holes of the outer plate.
9 Remove rivet press tool (2).

Component Identification:

10 Turn over moving assembly insert (4) with the digit D5 to the riveting section (arrow).

Component Identification:

11 Position riveting tool (2) exactly above the middle of the pins (arrow).
12 Tighten spindle (7) fully at riveting tool (2).
Tightening torque of spindle: Reference value approx. 30 to 35 Nm.
13 Rivet pins of the riveted link individually.

Component Identification:

14 Check riveting (arrows), re-rivet if necessary.
15 Fit on camshaft sprocket (6).
Pay attention to tightening torque of camshaft sprocket.
The colored markings (8) on the timing chain and at the camshaft sprocket must be aligned.