GF30.30-P-0001M Cruise Control (CC) Function

GF30.30-P-0001M Cruise Control (CC) Function
- ENGINE 275.950 in MODEL 215, 220
- ENGINE 275.951 in MODEL 230 up to Model Year 8
- ENGINE 275.953 in MODEL 216, 221 up to Model Year 8
- ENGINE 275.954 in MODEL 230 up to Model Year 8
- ENGINE 275.980 in MODEL 215, 220
- ENGINE 275.981 in MODEL 230 up to Model Year 8
- ENGINE 275.982 in MODEL 216, 221 up to Model Year 8
- ENGINE 285.950 in MODEL 240
- ENGINE 285.980 in MODEL 240





Illustrated model 215, 220, 230, 240
B37 Accelerator pedal sensor
M16/6 Throttle valve actuator
N3/10 ME-SFI control unit
N15/3 ETC [EGS] control unit (transmission 722.6)
N47-5 ESP, SPS [PML] and BAS control unit
N80 Steering column module
S9/1 Stop lamp switch
S40 CC [TPM] switch (United State of America)(Japan)
S40/4 TPM with variable speed limiter switch (Model 215, 220 and 240)
S40/4 Cruise control switch (model 230)
X11/4 Data link connector
CAN Data bus

The cruise control function must maintain the preselected speed constant irrespective of the load condition, without the accelerator pedal being operated.

The cruise control function can be activated at speeds above 40 km/h with the cruise control switch. Using the input signals and the position of the cruise control switch, the engine control unit actuates the throttle valve actuator for the cruise control function.

The cruise control mode is switched off by:
- Moving the cruise control switch into OFF position
- Actuation of the service brake (CAN message)
- Moving selector lever into position "N"
- Control intervention function of the traction system.

The signals from the cruise control switch are detected by the steering column module and transmitted via the CAN data bus to the engine control unit.

The speed signal is transmitted by the ESP control unit via the CAN to the engine control unit.