GF82.30-P-3008PQ Wiper Start Suppression Function

GF82.30-P-3008PQ Wiper Start Suppression Function

MODELS 203.0 /2 /7 as of 4/24/04







1 Circuit status
2 Request signal
3 Shift lever position
4 Vehicle speed signal
5 Driver/front passenger door status
6 Selector lever position (with transmission 722)
7 Engine hood status
8 Actuation and position feedback
A1 Instrument cluster
M6/1 Wiper motor
N10/1 Front SAM control unit with fuse and relay module
N10/2 Rear SAM control unit with fuse and relay module
N15/5 Electronic selector lever module control unit (with transmission 722)
N73 DI control unit
N80 Steering column module
S4 Combination switch
S16/2 Backup lamp switch (with transmission 716)
S17/3 Left door contact switch
S17/4 Right door contact switch
S62 ATA hood switch
CAN B Controller area network bus class B (interior compartment) (CAN B)
CAN C Controller Area Network bus, class C (engine compartment) (CAN C)

Function
Wiper operation is suppressed when:
- combination switch (S4) is in position "I" (windshield) and
- driver or passenger-side door is open
- speed is less than 5 km/h, or
- the engine hood is opened.

Opening the driver or passenger-side door does not interrupt wiper operation that is currently in progress. The wipers move to the park position.

The wipers resume operation after suppression if:
- the clutch is actuated (with transmission 716) or
- the selector lever is in position "D" or "R" (on transmission 722) or
- the speed is faster than 8 km/h or
- the combination switch (S4) is turned from position "I" (windshield) to position "II" or position "III".