GF82.30-P-3009PQ Automatic Wiper Control Function

GF82.30-P-3009PQ Automatic Wiper Control Function

MODEL 203.0 /2 /7 as of 24.4.04
- with CODE (345) Rain sensor
- up to Model Year 8







1 Circuit status
2 Position "I" (windshield)
3 Degree of wetting
4 Actuation and position feedback
B38/2 Rain/light sensor
M6/1 Wiper motor
N10/1 Front SAM control unit with fuse and relay module
N70 Overhead control panel control unit
N73 DI control unit N80 Steering column module
S4 Combination switch
CAN-B Controller area network bus class B (interior compartment) (CAN B)

Function prerequisites:
- Circuit 15R ON

Function
The automatic wiper control (rain sensor operation) function is switched on by turning the combination switch (S4) to position "I" (windshield).
The wiper motor is actuated (M6/1) depending on the degree of wetting of the windshield.
The rain/light sensor (B38/2) and the overhead control panel control unit (N70) evaluate the signals. M6/1The wiper system is actuated via CAN-B (CAN-B) by the front SAM control unit with fuse and relay module (N10/1).

Possible wiper levels:
- Intermittent wiper with variable intervals.
- Continuous wiping at the required wiping speed.

Emergency running
If the communication between the rain/light sensor (B38/2) and the overhead control panel control unit (N70) fails, intermittent operation is activated at fixed intervals (approx. 5 sec.).
The intermittent mode pauses are approx. 7.5 seconds with automatic speed reduction function (not on USA vehicles).