AR35.31-P-0550-19PA Mounting Crown Wheel on Differential

AR35.31-P-0550-19PA Mounting crown wheel on differential
- Rear axle center assembly dia. 185, 198, 210


Test values for rear axle differential

Test values for rear axle differential:

Rear axle differential gear set

Rear axle differential gear set:

Rear axle differential gear set

Rear axle differential gear set:

Rear axle center assembly crown wheel

Rear axle center assembly crown wheel:

Special Tools:

Component Identification:

1 Carefully clean ring gear bore and ring gear seat on differential case.
2 Heat ring gear (47a) to assembly temperature using a hot plate (080); when doing so, check temperature constantly using remote thermometer (070).

Component Identification:

3 Using assembly mandrel (046), clamp differential case in vise.
4 Put on suitable heat protection gloves and mount ring gear (47a) on differential case, applying light hammer blows (rubber hammer) if necessary.

Make sure that the markings (arrow) on the ring gear (47a) and differential case are in alignment.

Component Identification:

5 Tighten ribbed retaining bolts (13a) for securing the ring gear (47a) evenly and in a cross pattern.

Safety bolts with ribs (13a) must always be replaced after being used once.