C. Mounting the Linear Compensator, Ant Splitter, & MHI Control Module

C. Mounting the linear compensator, antenna splitter, and MHI control module to the bracket





1. Mount the linear compensator to the bracket front with four T15 Torx self-tapping screws (Arrows, Figure 5).

Note:
Position the linear compensator so the connector receptacles face the bracket end with the longer mounting arm (Figure 5)





2. Mount the antenna splitter removed in Section A, step 7 to the bracket with two kit-included, M10 plastic nuts (Figure 6).





3. Mount the MHI control module to the threaded studs on the bracket backside with three M5 hex nuts (Figure 7).

Note:
The MHI control module fits the keyed threaded studs only one way (i.e. it is not possible to incorrectly mount the MHI control module to the bracket).