Drive/Propeller Shaft
Testing and Inspection- AP41.10-P-4152Z Propeller Shaft - Checking Couplings For Damage
- AR41.10-P-0085-02P Measure Absolute Angle at Front and Rear Propeller Shafts
- AR41.10-P-0086-01P Retrieving Propeller Shaft Articulation Angles From Memory and Correcting If Necessary
- AR41.10-P-0086P Measure Propeller Shaft Alignment With Electronic Angle Meter
- AR41.10-P-0085-01PA Measure Absolute Angle at Transmission
- AR41.10-P-0086-02P Prepare Electronic Propeller Shaft Inclinometer
Service and Repair- Procedures
- AR41.10-P-0050-05DA Connect Sections of Propeller Shaft Long-Life Grease (NLGI Grade 2)
- AR41.10-P-0085-01P Measure Absolute Angle at Transmission
- AR41.10-P-0085-03P Measure Absolute Angle at Rear Axle Housing
- AR41.10-P-0085-01PA Measure Absolute Angle at Transmission
- AR41.10-P-0086-02P Prepare Electronic Propeller Shaft Inclinometer
- Removal and Replacement
- AR41.10-P-0050-02EA Dismantle Front Propeller Shaft From Transmission
- AR41.10-P-0050-03EA Detach Rear Propeller Shaft From Rear Axle Center Assembly
- AR41.10-P-0050-04EA Mount Rear Propeller Shaft to Rear Axle Center Assembly
- AR41.10-P-0050-07EA Mount Front Propeller Shaft to Transmission
- AR41.10-P-0050P Remove/Install Propeller Shaft
- AR41.10-P-0200P Replacing Centering Sleeve
- Overhaul
- AR41.10-P-0100-01DA Pulling Off Rubber Mount With Grooved Ball Bearing and Front Protective Cap
- AR41.10-P-0100-02DA Pressing grooved ball bearing out and in at rubber mount of propeller shaft
- AR41.10-P-0100-05DA Pressing Rubber Mount With Grooved Ball Bearing Onto Joint Fork
- AR41.10-P-0100-06DA Pull Rubber Sleeve Onto Joint Fork
- AR41.10-P-0200-02DA Removal of Centering Sleeve
- AR41.10-P-0200-03P Press In Guide Sleeve
- Procedures
Specifications