Procedures
AZ82.70-P-0002-01P Retrofit Antenna Line
- with CODE (494) USA version
1 Connect antenna plug (6) of antenna line (5) to antenna connector (7) of antenna extension line (8).
2 Route antenna extension line (8) along on-board wiring harnesses as per picture in the trunk lid and fasten such that they do not chafe.
3 Route antenna line (5) of SDAR antenna (2) as per picture in the trunk lid and fasten in place using self-adhesive felt (see arrow).
4 Route antenna extension line (8) along on-board wiring harnesses as per picture onto trunk lid hinge and into the luggage compartment and fasten such that it does not chafe.
5 Route antenna extension line (8) along on-board wiring harnesses as per picture from left to right side of luggage compartment on rear center section to installation location of SDAR control unit (1) and secure such that it does not chafe against other components.
The SDAR control unit (1) is installed at a later stage. The antenna extension line (8) together with the power supply line branch-off (52) of the SDAR wiring harness is at a later stage secured such that it does not chafe against other components. The antenna plug (9) of the antenna extension line (8) is connected to the SDAR control unit (1) at a later stage.