AZ82.60-P-0015-02TX Retrofit Rear Entertainment Wiring Harness

AZ82.60-P-0015-02TX Retrofit Rear Entertainment Wiring Harness
- MODEL 219.3
- with CODE (242) Electrically adjustable front passenger seat with memory

Routing diagram






1 Video control unit
2 Control unit
3 Screen (left)
4 Screen (right)
5 Fuse carrier
N32/2 Front passenger front seat adjustment control unit with memory

Connection scheme






1 Video control unit
2 Control unit
3 Screen (left)
4 Screen (right)
5 Fuse carrier
6 Wiring harness (right screen)
7 Wiring harness (center console)
8 Wiring harness (left screen)
9 Wiring harness (video)
10 Black 4-pin coupling (vehicle wiring harness)
N32/2 Front passenger front seat adjustment control unit with memory

Ensure that the wiring harnesses are not damaged by chafing or being trapped otherwise the appropriate wiring harness must be replaced.
A wiring harness is not fitted because the installation kit contains the parts for vehicles with code (242) Electrically adjustable front passenger seat with memory and for vehicles without code (242) Electrically adjustable front passenger seat with memory.






1 Route wiring harness (6) from previously created opening in backrest to video control unit (1).
The video control unit (1) is only placed in the seat and is fastened at a later point.

2 Connect wiring harness (6) to video control unit (1).
The white 12-pin coupling (6.1) is connected at a later point.
The connections at video control unit (1) are coded and cannot be swapped.

3 Fasten wiring harness (6) at seat frame using cable ties.
4 Strap down excess length of line from wiring harness (6) using cable ties.






5 Route wiring harness (9) from control unit (2) to passenger-side front seat adjustment control unit with memory (N32/2).
The control unit (2) is only placed in the seat and is installed at a later point.

6 Connect wiring harness (9) to control unit (2) and to video control unit (1).
7 Fasten wiring harness (9) at seat frame using cable ties.






8 Detach black 4-pin coupling (10) of vehicle wiring harness from passenger-side front seat adjustment control unit with memory (N32/2) and connect with black 4-pin connector (9.1) of wiring harness (9).
9 Attach black 4-pin coupling of wiring harness (9) at passengerside front seat adjustment control unit with memory (N32/2) at outer left slot.
10 Fasten wiring harness (9) and fuse carrier with cable ties to seat frame.
The fuse rating is 5 A.






11 Connect wiring harness (7) to video control unit (1) and route to left side of seat frame on driver seat.
To ensure a seat adjustment in the longitudinal direction, the wiring harness (7) below the seat must be routed with a loop. Wiring harness (7) is routed below floor coverings. When routing, lift the center console and tilt the seats.

12 Connect wiring harness (7) to wiring harness (8) and fasten wiring harness (8) and wiring harness (7) in place using cable ties.