AZ82.60-P-0015-02TY Retrofit Rear Entertainment Wiring Harness

AZ82.60-P-0015-02TY Retrofit Rear Entertainment Wiring Harness
- MODEL 219.3
- except CODE (242) Electrically adjustable front passenger seat with memory

Routing diagram






1 Video control unit
3 Screen (left)
4 Screen (right)
5 Fuse carrier

Connection scheme






1 Video control unit
3 Screen (left)
4 Screen (right)
5 Fuse carrier
6 Wiring harness (right screen)
7 Wiring harness (center console)
8 Wiring harness (left screen)
9 Wiring harness (video)
24 Black 4-pin coupling
25 Black 4-pin plug
X55/4 Right front seat contacting strip

Ensure that the wiring harnesses are not damaged by chafing or being trapped otherwise the appropriate wiring harness must be replaced.
A wiring harness and a control unit are not fitted because the installation kit contains the parts for vehicles with code (242) Electrically adjustable front passenger seat with memory and for vehicles without code (242) Electrically adjustable front passenger seat with memory.






1 Route wiring harness (6) from previously created opening in backrest to video control unit (1).
The video control unit (1) is only placed in the seat and is fastened at a later point.

2 Connect wiring harness (6) to video control unit (1).
The white 12-pin coupling (6.1) is connected at a later point.
The connections at video control unit (1) are coded and cannot be swapped.

3 Fasten wiring harness (6) at seat frame using cable ties.
4 Strap down excess length of line from wiring harness (6) using cable ties.






5 Route wiring harness (9) from video control unit (1) to right front seat connector block.
6 Connect wiring harness (9) to video control unit (1).
The connections at video control unit (1) are coded and cannot be swapped.

7 Fasten wiring harness (9) at seat frame using cable ties.






8 Detach and disconnect right front seat connector block (X55/4).
9 Connect black, 4-pin coupling (9.1) and black, 4-pin connector (9.2) of wiring harness (9) to detached connector block for right front seat (X55/4).
The black 4-pin coupling (9.1) and the black 4-pin connector (9.2) are coded and cannot be swapped.






10 Connect assembled connectors and fuse carrier at the carrier (33).
The fuse rating is 5 A.

11 Fasten wiring harness with cable ties.






12 Connect wiring harness (7) to video control unit (1) and route to left side of seat frame on driver seat.
To ensure a seat adjustment in the longitudinal direction, the wiring harness (7) below the seat must be routed with a loop. Wiring harness (7) is routed below floor coverings. When routing, lift the center console and tilt the seats.

13 Connect wiring harness (7) to wiring harness (8) and fasten wiring harness (8) and wiring harness (7) in place using cable ties.