AZ82.60-P-0015-02SXA Retrofit Rear Entertainment Wiring Harness

AZ82.60-P-0015-02SXA Retrofit Rear Entertainment Wiring Harness
- MODEL 221.0## /1## 1#

Routing diagram






1 Video control unit
2 Rear entertainment control unit
3 Screen
5 Fuse carrier
N32/2 Right front seat control unit

Connection scheme






1 Video control unit
2 Rear entertainment control unit
3 Screen
5 Fuse carrier
6 Wiring harness (screen)
9 Wiring harness (video)
10 White 14-pin coupling (vehicle wiring harness)
N32/2 Right front seat control unit

Ensure that the wiring harnesses are not damaged by chafing or being trapped otherwise the appropriate wiring harness must be replaced.
The following operation steps are shown on the right side of the vehicle and can be accomplished analogously on the left side of the vehicle.






1 Route wiring harness (6) from previously created opening in backrest to video control unit (1).
The video control unit (1) is only placed in the seat and is fastened at a later point.

2 Connect wiring harness (6) to video control unit (1).
The white 12-pin coupling (23) is connected at a later point.
The connections at video control unit (1) are coded and cannot be swapped.

3 Fasten wiring harness (6) at seat frame using cable ties.
4 Strap down excess length of line from wiring harness (6) using cable ties.






5 Route wiring harness (9) from rear entertainment system control unit (2) to right front seat control unit (N32/2).
The rear entertainment control unit (2) is only placed in the seat and is fastened at a later point.

6 Connect wiring harness (9) to rear entertainment control unit (2) and to video control unit (1).
7 Fasten wiring harness (9) at seat frame using cable ties.
Take care that the adjustment mechanism of the seat is not impaired by the installation of lines, as this may lead to shearing or crushing of the wiring harness (9).
Note displayed routing and fastening of wiring harness (9).






8 Detach white 14-pin coupling (10) of vehicle wiring harness from right front seat control unit.
9 Route wiring harness (9) with white 14-pin plug (24) to right front seat control unit.






10 Attach white 14-pin coupling (10) of vehicle wiring harness to white 14-pin connector (24) of wiring harness (9).
Wrap felt tape around the created connector.

11 Attach white 14-pin coupling (25) to right front seat control unit.
12 Fasten wiring harness (9) at seat frame using cable ties.