GF91.29-P-3005SXA Seat Calibration, Function

GF91.29-P-3005SXA Seat Calibration, Function
- with CODE (223) Rear bench seat with electrically adjustable outer seats with PRE-SAFE positioning function for outer seats and outer head restraints

Function
Normalization is the assignment between the absolute adjustment position and the position detected by the rear seats control unit (N25/6).Normalization must be performed during initial start-up or in a denormalized condition.

Normalization procedure
The system has to move to the following positions:
^ Fore/aft adjustment to the rear stop
^ Angle adjustment to the up-stop
^ Backrest adjustment to the rear stop
^ Head restraint adjustment to the front stop

To do this, operate the respective switch (S55/1s1, S55/1s2, S55/1s3, S55/1s5, S55/2s1, S55/2s2, S55/2s3 and S55/2s5) in the left rear seat operation switch group (S55/1) or in the right rear seat operation switch group (S55/2) for seat adjustment until the system has moved to the mechanical stop and hold depressed for another 250 ms.

If normalization is successful, the rear seats control unit switches off the corresponding motor (M18/15, M18/16, M18/17, M18/18, M18/19, M18/20, M27/11 and M28/11).

Denormalization
An adjustment is denormalized:
^ when the mechanical stop has been passed or
^ when the waiting time of at least 5 s after a seat adjustment until battery voltage has been disconnected is not observed or
^ when a defective Hall sensor is recognized.