GF54.30-P-2020SX Settings on Workshop Level, Function

GF54.30-P-2020SX Settings On Workshop Level, Function

Adjust workshop level in the instrument cluster (A1)
The function requirements for adjusting the workshop level:
^ Circuit 15R ON
^ The basic display of the trip computer is shown in the multifunction display (A1p13) of the instrument cluster

The following steps must be carried out in order to get into the workshop level which is shown in the multifunction display of the instrument cluster:
^ Press the accept phone call button of the accept/terminate phone call button (S111s3) and keep pressed.
^ Within 1 s of pressing and when keeping the accept/terminate phone call button pressed, press the OK button (S110s6) as well and keep it pressed.
^ Keep both buttons pressed down for at least 5 seconds until the basic display of the workshop level is displayed.

The workshop level can be exited again using the "Back" and SBS off button (S110s4) again.

Basic display of workshop level shown on model 221 up to 31.8.06







It is possible to change between the following submenus using the scroll forward/back button (S110s1) of the multifunction steering wheel (MFL):
^ Vehicle data
^ Dynamometer test mode
^ ASSYST Plus workshop

Vehicle data
It is possible to inquire after the following information in the vehicle data submenu:
^ On-board electrical system voltage display
^ Vehicle model
^ Installed engine variant
^ Vehicle identification number (VIN)

Switch on roller test mode
With the roller test mode the wheel speeds of the driven axle are reflected in the non-driven axle. This is necessary on the brake test stand so that no error is entered in the ESP control unit (N47-5).
To do this, the following adjustment must be made:
^ Adjust the workshop level in the multifunction display.
^ Operate the scroll forward/back button until the roller test mode appears in the multifunction display.
^ Switch on the roller test mode with the OK button.

In the roller test mode submenu it is possible to choose between the function "ON" and "Off with circuit 15 OFF". The respective function is activated with the "Back" and SBS off button.
The functions "ON" and "Off with circuit 15 OFF" differ as follows:
^ If the condition "ON" is selected the roller test mode submenu is shown again after a status change from "circuit 15R OFF" to "circuit 15R ON" (reminder notification).
^ If the condition "Off with circuit 15 OFF" is selected, the basic display of the trip computer is shown after a status change from "circuit 15R OFF" to "circuit 15R ON".

Dynamometer test condition "ON" shown on model 221 up to 31.8.06







If the condition "ON" is selected the roller test mode submenu is shown again after a status change from "circuit 15R OFF" to "circuit 15R ON" (reminder notification).

Dynamometer test condition "Off with circuit 15 OFF" shown on model 221 up to 31.8.06







If the condition "Off with circuit 15 OFF" is selected, the basic display of the trip computer is shown after a status change from "circuit 15R OFF" to "circuit 15R ON".