AR40.20-P-0322-01SX Install Repair Bolt

AR40.20-P-0322-01SX Install repair bolt

Component Identification:

Camber, model 221 without 4MATIC shown

Component Identification:

Caster, model 221 without 4MATIC shown

Repair bolt to spring control arm:

Repair bolt to torque strut:

Repair bolt to spring control arm and torque strut:

Component Identification:

1 Jack up vehicle at the front (the suspension must be fully rebounded).
2 Remove series bolt (19a) with nut (19f) on spring control arm (17).

For camber correction.

Shown on model 221 without 4MATIC

Component Identification:

3 Remove standard bolt (19a) with nut (19f) to torque strut (18).

For caster correction.

Shown on model 221 without 4MATIC

Component Identification:

4 To adjust the camber and power-down, replace each standard bolt connection (A) to the torque strut (18) or spring control arm (17) with a repair bolt repair bolt (B).

The standard bolt (19a) is centered by lock tabs in the front axle carrier. Inserting the graduated disks (19d) onto the lock tabs, enables the repair bolt (19c) to be installed through the groove on the right or left.

The repair bolt (19c) may not be turned after fixing. Otherwise the lock tabs in the front axle carrier may be damaged.

Do not yet tighten nut (19b) to enable the rubber mount on the torque strut (18) or of the spring control arm (17) to rotate when the vehicle is rocked to settle the suspension.