I. Version Coding
I. Version Coding1. Connect Star Diagnosis to the vehicle.
Note:
Use a battery charger when performing all version coding and software updates.
2. Set the instrument cluster in accordance with STAR Bulletin P-B-54.30/141a Instrument Cluster SCN Coding for Component Replacement or Dealer Installed Accessories," or STAR Bulletin S-B-58.00/144a On-Line SCN Coding Instructions for the STAR Diagnosis System, February 2006," to recognize presence of the cellular telephone control module.
3. Set the Tele Aid control module to recognize presence of the telephone via path:
Control units > Information and communication > Audio, video, navigation and telematics > TELE-AID > Control unit adaptations > Model series, Airbag, Mobile phone > Set "Telephone adapter for portable CTEL (UHI-Universal Handy Interface" to FITTED, press F5 > F3: Yes/Coding > F2 to confirm the coding was carried out.
4. Set the MOST ring configuration to match Figure 35 via path:
Control units > Information and communication > Audio, video, navigation and telematics > COMAND - COMAND with integral telematics gateway > Control unit adaptations > Read coding and change if necessary > Adopt the actual configuration of the MOST and telematics CAN bus control units as the specified configuration > Verify that "Cellular telephone" and "Voice Control" are listed under Actual Value and configuration of the MOST components matches Figure 35 > F2: To continue > F3: Yes, to write the current actual configuration to MOST master > F2: To continue.
Note:
The MOST ring configuration in Figure 35 is an example of a configuration including every component. Some installations will not include all the components shown in the example. If a component is not present, connect the preceding component to the component following the one not present.
NOTICE!
Match the MOST ring configuration to Figure 35. Failure to have the configuration match Figure 35 will result in erroneous system operation and/or intermittent malfunctioning of some or all components. Do not alter the configuration in Figure 35 to match the vehicle configuration.
5. Restart the optical ring via path:
Control units > Information and communication > Audio, video, navigation and telematics > Restart optical ring.
Note:
Needed only for Star Diagnosis 11/05 and earlier.
6. Check for new software using the Telematics Flash update disc via path:
Control units > Information and communication > Audio, video, navigation and telematics > Restart optical ring > COMAND with integral telematics gateway > Control unit adaptations > Control module programming
Note:
Insert Telematics Flash CD (A 221 827 21 59) into the vehicle CD changer when performing the software update.
7. Check the DTC memory of all installed components and the head unit. Investigate and identify any present DTCs. Once identified, correct the source of the DTCs and clear the DTC memory.
Note:
Powering up the newly installed system prior to version coding will set errors in the MOST ring configuration. Ignore these errors during the initial DTC check. If the DTCs return after clearing, a configuration error is present. Locate and correct the error.
8. Confirm no new DTCS are present in the MOST system group.