G. Installing Linear Compensator Bracket Assembly and Conn. Linear Compensator

1. Mount the linear compensator/bracket assembly to the three threaded studs (Figure 18) on the equipment carrier-left of the mounted MHI/antenna switch bracket assembly-with three 8 mm nuts.





2. Connect the FAKRA antenna female connector to the linear compensator jack labeled "ANTENNA" (A, Figure 19).

3. Connect the FAKRA antenna male connector to the linear compensator jack labeled "PORTABLE" (B, Figure 19).

4. Connect the 4-pin power supply connector to the linear compensator (C, Figure 19).





5. Organize and wire tie loose cabling (Figure 20) and remount the equipment carrier.

^ Refer to WIS document AR68.30-P-4810V, "Remove/install center trunk paneling"