AZ82.60-P-0015-02CXA Retrofit Rear Entertainment Wiring Harness

AZ82.60-P-0015-02CXA Retrofit Rear Entertainment Wiring Harness
- MODEL 204.0## /2## /9## 1#
- except CODE (242) Electrically adjustable front passenger seat with memory
- except CODE (275) Memory package (driver seat, steering column, mirrors)

Routing diagram






1 Video control unit
3 Screen
5 Fuse carrier

Connection scheme






1 Video control unit
3 Screen
5 Fuse carrier
6 Wiring harness (screen)
9 Wiring harness (video)
24 Black 2-pin coupling
25 Black 2-pin connector
X55/4 Front passenger seat connector block

Make sure that the wiring harnesses are not damaged by chafing, pinching or crushing, as otherwise the corresponding wiring harness may have to be replaced.
The following operation steps are shown on the right side of the vehicle and can be accomplished analogously on the left side of the vehicle.






1 Route wiring harness (6) from previously created opening in backrest to video control unit (1).
The video control unit (1) is only placed in the seat and is fastened at a later point.

2 Connect wiring harness (6) to video control unit (1).
The white 12-pin coupling (23) is connected at a later point. The connections at video control unit (1) are coded and cannot be swapped.

3 Fasten wiring harness (6) at seat frame using cable ties.
4 Strap down excess length of line from wiring harness (6).






5 Route wiring harness (9) from video control unit (1) to front passenger seat connector block.
The video control unit (1) is only placed in the seat and is fastened at a later point.

6 Connect wiring harness (9) to video control unit (1).
7 Fasten wiring harness (9) at seat frame using cable ties.
Take care that the adjustment mechanism of the seat is not impaired by the installation of lines, as this may lead to shearing or crushing of the wiring harness (9).






10 Connect assembled connectors and fuse carrier at the carrier (33).
The fuse rating is 5 A.

11 Fix wiring harness in place with cable ties.