AZ82.60-P-0015-02CWA Retrofit Rear Entertainment Wiring Harness

AZ82.60-P-0015-02CWA Retrofit Rear Entertainment Wiring Harness
- except CODE (864) Rear entertainment system
- except CODE (275) Memory package (driver seat, steering column, mirrors)

Component Identification:

Make sure that the wiring harnesses are not damaged by chafing, pinching or crushing, as otherwise the corresponding wiring harness may have to be replaced.

1 Route wiring harness (6) from previously created opening in seat to video control unit (1).

The video control unit (1) is only placed in the seat and is installed at a later point.

2 Connect wiring harness (6) to video control unit (1).

The white 12-pin coupling (23) is connected at a later point.

3 Fasten wiring harness (6) at seat frame using cable ties.
4 Strap down excess length of line.

5 Route wiring harness (9) from video control unit (1) to left front seat connector block.

The video control unit (1) is only placed in the seat and is installed at a later point.

6 Connect wiring harness (9) to video control unit (1).
7 Fasten wiring harness (9) at seat frame using cable ties.

Take care that the adjustment mechanism of the seat is not impaired by the installation of lines, as this may lead to shearing or crushing of the wiring harness (9).

8 Detach and disconnect left front seat connector block (X55/3).
9 Connect black 2-pin coupling (24) and black 2-pin connector (25) with disconnected left front seat connector block (X55/3).

The black 2-pin coupling (24) and the black 2-pin connector (25) are coded and cannot be swapped.

10 Connect assembled connectors and fuse carrier at the carrier (33).
11 Fix wiring harness in place with cable ties.

12 Connect wiring harness (7) to video control unit (1) and route to previously created opening in backrest on passenger side.

To ensure a seat adjustment in the longitudinal direction, the wiring harness (7) below the seat must be routed with a loop. Wiring harness (7) is routed below floor coverings. When routing, lift the center console and tilt the seats.

13 Connect wiring harness (7) with right screen wiring harness (8) and fasten right screen wiring harness (8) with cable ties.