AZ82.60-P-0001-02SC Retrofit iPod Wiring Harness

AZ82.60-P-0001-02SC Retrofit iPod Wiring Harness
- except CODE (498) Japan version
- with CODE (386) Preinstallation for telephone "Handy", UPCI system
- with CODE (388) Telephone "Handy", UPCI system

1 Remove glove box lamp (E13/1) from glove box (4).
2 Release damping material (8) from glove box (4) as per picture and fold upwards.

3 Drill hole (C) with �=20 mm in glove box (4) as per dimensioning.

Ensure that no other components are damaged when drilling the hole (C).

Component Identification:

4 Slide interface coupling (5) of iPod wiring harness (1) from the inside to outside through hole drilled in glove box (4).
5 Seal hole with grommet (6) of iPod wiring harness (1).
6 Install glove box lamp (E13/1) in glove box (4).
7 Secure damping material (8) over drilled hole and iPod wiring harness (1) to glove box (4) as per picture.
8 Position glove box (4) with Pod wiring harness (1) in front passenger footwell.

iPod coupling (2) is connected to iPod at a later point in time. Interface connector (5) is connected to the iPod interface at a later time.