AN82.61-P-0001-05TB Perform Version Coding Subsequently

AN82.61-P-0001-05TB Perform Version Coding Subsequently

The described STAR DIAGNOSIS menu guidance corresponds to the German DAS version 05/2004 and may deviate from other versions.

1 Connect STAR DIAGNOSIS to data link connector (X11/4).
2 Start DAS, enter vehicle model and select the "Control units" menu item.
3 In the "Control unit groups" menu, select the subgroups
- "Information and communication"
- "Audio, video, navigation and telematics"
- "AGW audio gateway"
- "Retrofitting MOST components"
one after the other.

4 In the "Retrofitting MOST components" menu, perform the listed program run and transfer the new MOST ring sequence into the control unit.

Shown on model 211.2







5 Go from the "Retrofitting MOST components" menu back to the "Information and communication" menu and select the subgroups
- "IC instrument cluster"
- "Control unit adaptations"
- "Variant coding"
- "Special equipment"
one after the other.

6 In the "Special equipment" menu change the "Navigation" menu item from "not available" to "available" and transfer the coding into the control unit.
7 Go from the "Special equipment" menu back to the "Control unit groups" menu and select the subgroups
- "Body"
- "System diagnosis"
"Control unit adaptation"
- "Read coding and change if necessary"
- "Specified configuration of interior CAN bus"
one after the other.

8 In the "Specified configuration of interior CAN bus" menu, check status of installed equipment, correct if necessary and transfer into control unit.
9 Go from "Specified configuration interior CAN bus" menu back to the "Control unit adaptations" menu and select the subgroup "Knowledge base configuration".
10 In the "Knowledge base configuration" menu, activate the "Self configuration" menu item.
11 After completing the "Self configuration", go from the "Knowledge base configuration" menu back to the "Main groups" menu, run a quick test and delete the complete fault memory.
12 End the DAS and disconnect STAR DIAGNOSIS