AZ82.85-P-0005-04CW Retrofit Mercedes-Benz InCar Internet Control Unit

AZ82.85-P-0005-04CW Retrofit Mercedes-Benz InCar Internet Control Unit
- MODEL 204.0## /2## 1#

Connection diagram with code (518) Media interface






1 InCar Internet control unit
2 Connecting cable
2.1 Blue, 1-pin coupling for connecting cable
3 InCar Internet adapter wiring harness
5 Black 32-pin coupling
14 Media interface adapter line
15 Low voltage differential signal (LVDS) display wiring harness
15.2 LVDS display wiring harness coupling
16 LVDS head unit wiring harness
16.2 LVDS head unit wiring harness coupling
18 Media interface adapter line electrical connector
A40/3 COMAND control unit
A40/8 Audio/COMAND display
X18/70 Media interface electrical connector

Connection diagram without code (518) Media interface






1 InCar Internet control unit
2 Connecting cable
2.1 Blue, 1-pin coupling for connecting cable
3 InCar Internet adapter wiring harness
5 Black 32-pin coupling
15 Low voltage differential signal (LVDS) display wiring harness
15.2 LVDS display wiring harness coupling
16 LVDS head unit wiring harness
16.2 LVDS head unit wiring harness coupling
A40/3 COMAND control unit
A40/8 Audio/COMAND display

Routing diagram with code (518) Media interface






1 InCar Internet control unit
2 Connecting cable
14 Media interface adapter line
A40/3 COMAND control unit

Routing diagram without code (518) Media interface






1 InCar Internet control unit
2 Connecting cable
A40/3 COMAND control unit






1 Remove rubber insulation in front passenger footwell in crosshatched area.
Do not damage insulation underneath.






2 Stick double-sided adhesive tape (17) onto rear of InCar Internet control unit (1).
3 Connect black, 32-pin coupling (5) of InCar Internet adapter wiring harness (3), coupling for LVDS display wiring harness (15.2) of LVDS display wiring harness (15) and coupling for LVDS head unit wiring harness (16.2) of LVDS head unit wiring harness (16), as shown, to InCar Internet control unit (1).






4 Connect blue 1-pin connecting cable coupling (2.1) of connecting cable (2) to InCar Internet control unit (1).
5 Detach carrier foil of double-sided adhesive tape and stick InCar Internet control unit (1), as shown, onto the propeller shaft tunnel.
Do not compress condensation drain hose (25) of the air conditioner housing, otherwise condensation may not be able to drain from the air conditioning system.






6 Strap down excess lengths of connected lines for InCar Internet control unit (1) and fasten in place using felt tape (24).
7 Detach white 4-pin coupling (3.1) and white 4-pin connector (3.2) of InCar Internet adapter wiring harness (3).
In vehicles with code (518) Media Interface.

8 Connect white 4-pin coupling (3.1) with white 4-pin connector (14.1) of media interface adapter line (14).
In vehicles with code (518) Media Interface.






9 Connect black 1-pin coupling (18.1) of media interface electrical connector adapter line (18) to adapter wiring harness for intelligent head unit.
In vehicles with code (518) Media Interface.

10 Connect black 24-pin plug (18.2) with media interface electrical connector.
In vehicles with code (518) Media Interface.






11 Remove foam insulation (26.1) of floor covering (26) in crosshatched area.
Do not damage the floor covering (26) underneath. The floor covering (26) will be installed at a later stage.