AZ82.85-P-0004-05CX Retrofit Universal Media Interface Connecting Cable

AZ82.85-P-0004-05CX Retrofit Universal Media Interface Connecting Cable
- MODEL 204.0## /2## /3## (except 204.077 /277 /377) 1# Kit with Cable






1 Open lid of glove box (22).
2 Make cutout on glove box (22), as shown. Cordless drill/driver
gotis://G_58.0_01.1
Body jig saw
gotis://K_58.1_01.0

The cutout is partly pre-perforated, if this is not the case, make cutout to following dimensions:
a = 15 mm
b = 60 mm
c = 5 mm
d = 25 mm






3 Reduce wall thickness for glove box in cross-hatched area using square file.
The wall thickness of the glove box has to be reduced such that the catch hooks of the covering for the Universal Media Interface connecting cable can latch into place.






4 Wrap felt tape around Universal Media Interface connecting cable (2) behind covering (2.3).
5 Open lid of glove box (22).
6 Route Universal Media Interface connecting cable (2) from inside through the opening in the glove box (22) and clip in covering (2.3) of Universal Media Interface connecting cable (2) from inside into glove box (22).
Make sure that the catch hooks (2.4) are latched into place.






7 Use felt tape (23) to fasten Universal Media Interface connecting cable (2) onto glove box (22).