AN31.11-P-8080-09CW Prepare Body For Installation of Trailer Hitch Wiring Harness

AN31.11-P-8080-09CW Prepare Body For Installation Of Trailer Hitch Wiring Harness
- 204.0## 1#

Repair Materials:

1. Remove stop plug (1) from rear center section.
2. Determine diameter of grommet (2) on trailer hitch wiring harness (3) and at rear center section.
The diameter on the rear center section is either 36 mm or 40 mm.

3. Drill bore on rear center section to a diameter of 40 mm.
Step drill bit
Cordless drill/driver

Only when diameter on rear center section is 36 mm.

4. Treat bore with epoxy filler and dry for 30 minutes with an infrared drier.
Hotspot handheld radiant heater with tripod

Only when diameter of bore on rear center section was drilled.