GF07.10-P-1005MI Ignition System Function

GF07.10-P-1005MI Ignition System Function

Function requirements for the ignition system, general points
^ Circuit 87M ON (engine control ON)

Ignition system, general points
A single-spark ignition coil is plugged directly into each cylinder. For the ignition system, the ME-SFI (N3/10) control unit reads the following sensors and signals:
- RH knock sensor (A16/1)
- LH knock sensor (A16/2)
- Hot film MAF sensor (B2/5), engine load
- Intake air temperature sensor (B2/5b1)
- LH and RH intake camshaft Hall sensor (B6/4, B6/5), intake camshaft positions
- LH and RH exhaust camshaft Hall sensor (B6/6, B6/7), exhaust camshaft positions
- Coolant temperature sensor (B11/4)
- Pressure sensor (B28), intake manifold air pressure
- Crankshaft Hall sensor (B70), engine speed and crankshaft position

The requirements of the torque coordination function are also taken into account.

For the following partial functions, ignition angle adjustment in the direction "retarded" or "advanced" takes place:
- Idle speed control
- Inertia fuel shutoff
- Transmission overload protection
- Knock sensor system
- Torque coordination

Ignition system function sequence
The ME-SFI [ME] control unit interrupts the respective ignition coil (T1) at the moment of the ignition timing at the ground end of the primary circuit to "circuit 1".

Determination of the ignition angle takes place dependent on a performance map according to the input signals from the ME-SFI [ME] control unit.

Component Identification:

Diagnosis
The ignition angles can be checked using the Xentry diagnostics