AR88.30-P-1000-03SX Prepare Body Flange For Gluing In Spare Tire Well

AR88.30-P-1000-03SX Prepare Body Flange For Gluing In Spare Tire Well

Repair Materials:

1. Cut remaining glue off of body flange on spare tire well with scraper

A maximum of 2 mm of adhesive material residue may be left. Pull off loose adhesive material (remaining pieces which are not completely cut off).

2. Clean painted bonding surface on spare tire well body flange with cleaner from repair set (BETACLEAN 3300) from 2- component glue set and rub dry with rag.
3.1 If glue on spare tire well body flange is damaged or defective, apply paint glass primer (BETAPRIME 5061) from 2-component glue set in area to be glued.

Allow primer to air-dry for min. 10 minutes.

4.1 Repair paint damages on spare tire well body flange not covered by glue with primer stick

In order to prevent adhesion faults when gluing in the spare tire well, the bonding surface of the body flange must be free of dust, oil, grease, wax and other cohesive components or dirt particles.

If sheet metal parts are replaced in the area of the spare tire well, treat gluing area of spare tire well with paint/glass primer (BETAPRIME 5061).