Suspension - Visit Workshop Mssg/DTCs 5320/5250/5260

Date: May 6, 2009

Order No.: S-B-32.22/78a

Supersedes: S-B-32.22/78 dated March 31, 2009

Group: 32

Revision History

Revision Date Purpose

a 5/6/09 WIS Document Reference Added (211.2)

- 3/31/09 Initial issue

SUBJECT:
All Model 164, 211, 219, 221 and 251 Vehicles Equipped with Airmatic
Suspension (Sales Code 489)

"Airmatic - Visit Workshop" Displayed Within Instrument Cluster





If you receive customer reports in the above model vehicles of "Airmatic Visit Workshop" being displayed within the instrument cluster and the respective fault code listed below, perform the following.

Note:
Do not unplug the connector at the drain valve, as it is necessary to inspect the harness connector and compressor in their original untouched state.

1. Cut the drain valve wire harness 10 cm before connector.

2. Install the new wire harness repair kit.





3. Replace the Airmatic compressor. Refer to the applicable WIS document.

Note:
This condition is the result of excessive resistance at the connector of the Airmatic compressor's drain valve.





Parts Information

Note:
The following allowable labor operations should be used when submitting a warranty claim for this repair. This information has been generated on March 31, 2009. Please refer to Netstar --> Star TekInfo --> Star Time for the most current labor time allowance.





In Case of Warranty, use the table above.