AZ82.60-P-0015-02T Retrofit Rear Entertainment Wiring Harness

AZ82.60-P-0015-02T Retrofit Rear Entertainment Wiring Harness
- except CODE (861) TV rear screen
- with CODE (275) Memory package (driver seat, steering column, mirrors)

Component Identification:

Ensure that the wiring harnesses are not damaged by chafing or being trapped otherwise the appropriate wiring harness must be replaced.

1 Route wiring harness (6) from previously created opening in backrest to video control unit (1).

The video control unit (1) is only placed in the seat and is fastened at a later point.

2 Connect wiring harness (6) to video control unit (1).

The white 12-pin coupling (23) is connected at a later point. The connections at video control unit (1) are coded and cannot be swapped.

3 Fasten wiring harness (6) at seat frame using cable ties.
4 Strap down excess length of line from wiring harness (6) using cable ties.
5 Route wiring harness (9) from control unit (2) to driver-side front seat adjustment control unit with memory (N32/1).

The control unit (2) is only placed in the seat and is installed at a later point.

6 Connect wiring harness (9) to wiring harness control unit (2) and to video control unit (1).
7 Fasten wiring harness (9) at seat frame using cable ties.

8 Detach black 4-pin coupling (10) of vehicle wiring harness from driver-side front seat adjustment control unit with memory (N32/1) and connect with black 4-pin connector (24) of wiring harness (9).
9 Attach black 4-pin coupling of wiring harness (9) at driver-side front seat adjustment control unit with memory (N32/1) at outer left slot.
10 Fasten wiring harness (9) at seat frame using cable ties.

11 Connect wiring harness (7) to video control unit (1) and route to previously created cutout in backrest on passenger side.

To ensure a seat adjustment in the longitudinal direction, the wiring harness (7) below the seat must be routed with a loop. Wiring harness (7) is routed below floor coverings. When routing, lift the center console and tilt the seats.

12 Connect wiring harness (7) with wiring harness (8) and fasten wiring harness (8) with cable ties.
13 Fix wiring harness (7) in place at vehicle wiring harness below left and right seat using cable ties.