AZ82.60-P-0015-02SX Retrofit Rear Entertainment Wiring Harness

AZ82.60-P-0015-02SX Retrofit Rear Entertainment Wiring Harness
- except CODE (864) Rear entertainment system

Component Identification:

Ensure that the wiring harnesses are not damaged by chafing or being trapped otherwise the appropriate wiring harness must be replaced.

1 Route wiring harness (6) from previously created opening in backrest to video control unit (1).

The video control unit (1) is only placed in the seat and is fastened at a later point.

2 Connect wiring harness (6) to video control unit (1).

The white 12-pin coupling (23) is connected at a later point. The connections at video control unit (1) are coded and cannot be swapped.

3 Fasten wiring harness (6) at seat frame using cable ties.
4 Strap down excess length of line from wiring harness (6) using cable ties.
5 Route wiring harness (9) from control unit (2) to left front seat control unit (N32/1).

The control unit (2) is only placed in the seat and is installed at a later point.

6 Connect wiring harness (9) to control unit (2) and to video control unit (1).
7 Fasten wiring harness (9) at seat frame using cable ties.

Note displayed routing and fastening of wiring harness (9).

8 Detach white 14-pin coupling (10) of vehicle wiring harness from left front seat control unit.
9 Route wiring harness (9) with white 14-pin connector (24) to left front seat control unit.

10 Attach white 14-pin coupling (10) of vehicle wiring harness to white 14-pin connector (24) of wiring harness (9).

Wrap felt tape around the created connector.

11 Attach white 14-pin coupling (25) on left front seat control unit.
12 Fasten wiring harness (9) at seat frame using cable ties.

13 Remove cover (26).
14 Connect wiring harness (7) to video control unit (1) and route to passenger side and fix in place with cable ties.

To ensure a seat adjustment in the longitudinal direction, the wiring harness (7) below the seat must be routed with a loop. Wiring harness (7) is routed below floor coverings. When routing, lift the center console and tilt the seats.

15 Install cover (26).

16 Remove cover (27).
17 Connect wiring harness (7) with right screen wiring harness (8) and route to previously created opening in backrest.

To ensure a seat adjustment in the longitudinal direction, the wiring harness (7) below the seat must be routed with a loop. Wiring harness (7) is routed below floor coverings. When routing, lift the center console and tilt the seats. The wiring harness (8) is attached to the screen at a later point.

18 Install cover (27).