AR35.20-P-0114-01SX Remove/Install Spring Control Arm Rubber Mount

AR35.20-P-0114-01SX Remove/Install Spring Control Arm Rubber Mount





220 589 01 43 00
Removal and installation tool





202 589 04 43 00
Extraction tool

1.1 Remove left rear muffler
When replacing the left rubber mount in the rear axle carrier.
1.2 Remove exhaust starting from the flange connection.
When replacing the right rubber mount in the rear axle carrier.





Pressing-out and pressing-in process of rubber mount

To move out the piston, screw in the pressure screw (010k) of the press (010h) until the piston is fully extended.
This process must be repeated approx. 5 times due to the short stroke of the press (010h)
To do this the piston is to be moved back by turning back the pressure screw (010k) and simultaneously tightening the hand wheel (068e). The spindle of the hand wheel (068e) must always exert a little pressure onto the press (010h) so that the tools cannot fall out.

Press out

2 Remove sleeve (068b) on bracket (068a).
3 Press out/in tool with thrust piece (068c) and Position press (010h) on rear axle carrier (1).
4 Secure press (010h) and thrust piece (068c) by tightening hand wheel (068e). In the process observe the chamfer (arrow) on sleeve (068b), it must abut the rear axle carrier (1) exactly.
5 Press out rubber bushing





Pressing in

6 Replace sleeve (068b) by sleeve (068f).
7 Insert rubber mount in bore of rear axle carrier (1).
8 Position press out/in tool with thrust piece (068g) and press (010h) on rear axle carrier (1).
9 Secure press (010h) and thrust piece (068g) by tightening hand wheel (068e). In the process observe the chamfer (arrow) on the sleeve, it must abut the rear axle carrier exactly.1
10 Press the rubber mount into the rear axle carrier (1) until the thrust piece (068g) abuts the rear axle carrier (1) (arrow).