AN82.60-P-0016-05SC Retrofit Video Signal Line

AN82.60-P-0016-05SC Retrofit Video Signal Line
- MODEL 216.3## (except 216.374 /377 /379) 1#






1 Wrap video signal line (11) with felt tape.
2 Route white 1-pin connector (11.1) of video signal line (11) from front passenger footwell to white 1-pin coupling (1.1) of previously installed media interface wiring harness (1).
3 Connect white, 1-pin connector (11.1) to white, 1-pin coupling (1.1) to form the media interface connector 1 (X18/67).
4 Route media interface connector 1 (X18/67) behind the right fuse box on the instrument panel (F1/6).






5 Position fuse box of right instrument panel (F1/6) and tighten with bolts (14).






6 Route video signal line (11) along media interface wiring harness to media interface control unit (N125/1) and fix in place with cable tie (17).






7 Remove black 20-pin contact carrier (11.2) from black 40-pin coupling (11.3) of video signal line (11).
The black 40-pin coupling (11.3) is no longer required.






8 Fold right front floor covering (18) to side in area of transmission tunnel.
9 Route video signal line (11), as shown, into the COMAND controller unit slot.
Route video signal line (11) behind hose (19). The video signal line (11) must be routed 200 mm out of the COMAND controller unit slot.






10 Form a loop with video signal line (11), as shown, and fix in place with cable tie (20) behind right front floor covering (18).






11 Remove transparent line (tr) of video signal line (11) from contact cavity 33 of black 20-pin contact carrier (11.2).
12 Remove screened line (sc) of video signal line (11) from contact cavity 22 of black 20-pin contact carrier (11.2).
The black 20-pin contact carrier (11.2) is no longer required.






13 Remove black 20-pin contact carrier (21.2) from black 40-pin coupling (21.1) of vehicle wiring harness (21).
14 Install transparent line (tr) of video signal line (11) in contact cavity 33 of black 20-pin contact carrier (21.2).
15 Install screened line (sc) of video signal line (11) in contact cavity 22 of black 20-pin contact carrier (21.2).
16 Install black 20-pin contact carrier (21.2) in black 40-pin coupling (21.1) of vehicle wiring harness (21).
17 Fix video signal line (11) in place at vehicle wiring harness (21) using cable tie.