AZ82.60-P-0001-02TXX Retrofit iPod Wiring Harness

AZ82.60-P-0001-02TXX Retrofit iPod Wiring Harness

Component Identification:

1 Measure the position of the hole corresponding to the dimensions listed below relative to the reference edges (15, 16)
2 Drill hole with a diameter of 20 mm in glove box. Rechargeable drill / screwdriver
gotis://G_58.0_01.1

3 Route iPod interface coupling (5) of iPod wiring harness (4) through previously drilled hole into front passenger footwell and close hole with grommet (6).

The iPod interface coupling (5) for the iPod wiring harness (4) will be connected to the iPod interface at a later point in time.
iPod wiring harness connector (23) will be connected to the iPod at a later point in time.