AZ82.60-P-0001-02SX Retrofit iPod Wiring Harness

AZ82.60-P-0001-02SX Retrofit iPod Wiring Harness

1 Remove glove compartment lamp (E13/1) from glove compartment (4).

2 Remove damping material (8) in the area (A) from rear of glove compartment (4).
3 Check whether no other components or wiring harnesses are installed in area (A) on rear of glove compartment (4).

Drill hole in area (A).

4 Drill hole (C) with � = 20 mm into glove compartment (4) as per the dimensioning.

Ensure that no other components are damaged when drilling hole (C).

Component Identification:

5 Route interface coupling (5) of iPod wiring harness (1) through drilled hole in glove compartment (4) into COMAND installation opening.
6 Seal hole with grommet (6).
7 Reinstall glove compartment lamp (E13/1) in glove compartment (4).

The iPod coupling (2) is later connected to the iPod. The interface connector (5) can be connected to the iPod interface later.