Reset Procedure

Restarting the TPMS

Warning! It is the driver's responsibility to set the tire inflation pressure to the recommended cold tire inflation pressure. Underinflated tires affect the ability to steer or brake the vehicle. You might lose control over the vehicle.

When you restart the TPMS, the system sets new reference values for each tire.

The TPMS must be restarted when you have adjusted the tire inflation pressure to a new level (e.g. because of different load or driving conditions). The TPMS is then recalibrated to the current tire inflation pressures.

Restart the TPMS after adjusting the tire inflation pressure to the inflation pressure recommended for the vehicle operating condition. Tire pressure should only be adjusted on cold tires. Observe the recommended tire inflation pressure on the Tire and Loading Information placard on the driver's door B-pillar. Some vehicles may have supplemental tire pressure information for driving at high speeds or for vehicle loads less than the maximum loaded vehicle condition.
If such information is provided, it can be found on the inside of the fuel filler flap.

- Using the Tire and Loading Information placard on the driver's door B-pillar or, if available, the supplemental tire inflation pressure information on the inside of the fuel filler flap, make sure the tire inflation pressure of all four tires is correct.

- Make sure that the SmartKey is in position 2 in the ignition lock.

- Press button LEFT or RIGHT on the multifunction steering wheel to select the Service menu.

- Press the button UP or DOWN on the multifunction steering wheel to select Tire Pressure.

- Press button OK.
The current inflation pressure for each tire appears in the multifunction display or the following message appears in the multifunction display:
Tire pressures will br displayed after driving a few minutes

- Press button DOWN.
The following message appears in the multifunction display:
Use Current Pressures as New Reference Values

If you wish to confirm the restart
- Press button OK.
The following message appears in the multifunction display:
Tire Press. Monitor Restarted

After driving a few minutes the system verifies that the current tire inflation pressures are within the system�s specified range. Afterwards, the current tire inflation pressures are accepted as reference values and then monitored.

- If you wish to cancel: Press button BACK.

- Press button UP to exit menu screen